طريقة الشحن كما وردت من المصدر
Matrix Reloaded how to ....
Programming the MR with latest firmware 1.03 using an Elvis programmer and 3
Fun5 cards was a peice of cake, don't forget to set the Extee to 24c512 in the
Elvis.
load the Flash file into the flash section
load the mr103_512_1-3 in the External Eeprom,each card takes approx 5.5mins to
write each card.
once you have programmed all three cards make sure you mark them 1-3 as they
have to be used in the correct order.
Make sure your MR is inserted into the receivers C.I Slot, then goto the cam
menu and select download for a new cam or update firmware if upgrading from a
previous firmware.
Insert Card 1 you will see the message (performing smart card download) once you
see the message (download card complete please extract it) Remove Card 1 then
press 'OK' you will then get the message (Insert Card 2) once you inserted card
2 press 'OK' you will then see the message (performing smart card download) once
you see the message (download card complete please extract it) Remove Card 2
then press 'OK' you will then get the message (Insert Card 3) once you inserted
card 3 press 'OK' you will then see the message (performing smart card download)
once completed the receiver will auto boot, you should now have the latest
version v1.03 firmware on your cam.
If you get invalid card or another error message remove card click 'OK'
reprogramme card and try again.
Each card will take approx 2 mins to complete.
Once updated to v1.03 select a channel on Digital+ (Hispasat)
I used 'Showtime' and in less than 1min it had auto updated and without a card
inserted in the cam pulled in all Digital+ channels, Cabo on the other hand gave
a picture after 5mins but it only lasted for around 3 seconds, due to attacks it
dont auto update, you will be required to add the keys manually, again this is a
simple process to do.
Updating Cabo Key 00 (Hispasat)
Goto cam menu select 'Setup' then 'Edit CAS key' select 'Nagravision' then
select 'Provider ID: 004901' thats the ID for Cabo, if updating Key 00: choose
0X00 click 'OK' then using either your computer calculator or the converter on
the 'Joker' page on insert the 2 digit hex key and convert it to
a 3 digit decimal key,once you converted the complete key make a note of the
decimal conversion as you will require this referance for adding to your cam.
Now that you have done the conversion and kept a note of the keys, all you have
to do now is insert the keys into the MR,as you already selected 0X00 for
'Provider 004901' the display on your screen should be --- enter the first 3
digit decimal key then press 'OK' you will have to enter 8x3 digital keys, once
all have been entered you will be asked if you want to save the Key,if your
happy the key has been entered correctly press 'OK' otherwise press 'Exit' not
to save, if you have made an error entering the key, simply start over again.
I have entered the MR digital keys for Nagravision on the 'Nagravision' Page of
the conversion to digital is already done, so all you need do is
enter the keys into your MR Cam
Laurals.com will be back on line within the next day or so, as we are now in the
process of upgrading
28-08-2003, 11:34 AM
العرض العادي
